Glock P80 parts check

Prudii

PMMEYOURCZPICS
Supporting Member
Multi-Factor Enabled
Joined
Jun 11, 2017
Messages
1,515
Location
Triad
Rating - 100%
35   0   0
I am fairly certain I have everything. Could an expert tell me what I am missing here.


p80clparts.jpg
 
And, i don't see the spring for the magazine release button.
 
I think I need a trigger spring as well.
 
A buddy of mine built a P80 last week, then took it to the range and shot 100rds, then brought it to my house to show it off.

Within 4 seconds of holding it, I said, "Where's your front sight?"

He said, "What are you taking about? "

It was gone....

Put some purple lock tight on that thing.

Haha
 
  • Like
Reactions: Me.
Slide release is wrong. You need the three pin version.
 
I don't see the striker safety plunger and spring.

ETA: maybe it is there standing on end. Small screen sucks.
 
Last edited:
  • Like
Reactions: Me.
Geez, did you go buy each part? You know they have kits, right? And usually it's cheaper. Go look at a upper and lower parts kit list and compare to see what's missing. I agree the trigger block and the mag release spring stand out. And the liner tool is technically not a part.
You going to mill, clip or grind?
 
It looks like a CL frame, so the little spring next to the rear rail is the slide lock spring.
 
Geez, did you go buy each part? You know they have kits, right? And usually it's cheaper. Go look at a upper and lower parts kit list and compare to see what's missing. I agree the trigger block and the mag release spring stand out. And the liner tool is technically not a part.
You going to mill, clip or grind?
Clip then file.
 
Back
Top Bottom