Pistol Picture Thread

MVDt1qs.jpg
 
@Gray I have a Suarez magwell on my G19 and really like it. Post #21.
 
How do you like the mag well? That's the last part I need for my Roland. Freya is backordered.
first impressions are that it is really well made and lightweight. It did crowd my big hands a little bit, but a little sand paper work on the trigger guard fixed that.

on a side note, what barrel did you go with on your Roland build?
 
first impressions are that it is really well made and lightweight. It did crowd my big hands a little bit, but a little sand paper work on the trigger guard fixed that.

on a side note, what barrel did you go with on your Roland build?

I did the KKM barrel and comp. Very pleased with it. If you are looking at building one and are looking at other barrel options think forward and look at holster options. Venture outside of the KKM setup and holster options get thin. Same applies for the light.
 
I did the KKM barrel and comp. Very pleased with it. If you are looking at building one and are looking at other barrel options think forward and look at holster options. Venture outside of the KKM setup and holster options get thin. Same applies for the light.

I've been searching everywhere for a s3f solutions barrel, but they seem like unobtainium.
 
Just ordered the Agency mag well from a local shop.
 
Last edited:
I've been searching everywhere for a s3f solutions barrel, but they seem like unobtainium.

Was able to find a Blacklist barrel in stock, which was my 2nd choice so I went with that.
 
e7ccd6804c7e2b7e0e120d70938997af.jpg


Sig P320c 9mm with a RMR RM 06, Galloway precision sights, Apex flat trigger, TR holster with Kryptek nomad pattern filled up with 147 gr gold dots hanging from a fat boy belt and accompanied by a zero tolerance 0350ts.


Sent from my iPhone using Tapatalk
 
Last edited:
Ended up sending my p01 Omega to Cajun gun works so my sp01 has been moved to house duty. Also cleaned some of my sp01s.
6f93f6e46d6c0c7384fca1493027011f.jpg
 
Last edited:
After looking at the professional quality of MacA's photo's I think I when I get home I will have to get out my good camera, go through The Boss Ladies fabric and set up a little studio of my own and take some pictures of my pistols. Dang man, the rest of us get out the cell phone snap a few quick photo's and post em.
 
  • Like
Reactions: NKD
If you cut the Ruger Mark 2/3/4 barrels down to 3.75-4" it will likely keep all .22 subsonic, including most bulk stuff.
 
Could I ask what that cost to do? I've got a markiii Hunter that I love, but also getting the itch for a can on a 22 pistol. Very cool piece.
He's at $185 now to move the site (it was still on target), thread the barrel, make the thread protector and turn it and the barrel to remove Ruger's warning bilboard. I was paranoid and read all over the place before I sent it off. I couldn't find a bad review, and found many folk saying send it to Jim, I found many comments on RimfireCentral.com and have seen HORRIBLE jobs done by others.
http://www.jpgrips.com/page7
May I also strongly suggest a Volquartzen firing group.
Let us know!
 
Last edited:
Back
Top Bottom