I have a couple lowers and uppers laying around and started building out a lower with the parts that I have on hand. Everything was going well until I started putting the front pivot pin in. I turned the lower around in the vice to make it a little easier to install the pin. I have done this a couple dozen times before without any problems. When pushing the take down pin through the lower the detent kept flying out. I am asking myself what in the hell is going on. Then I realized what I had done, When I turned the lower around, I was putting the take down pin on the wrong side of the lower. I got two detents laying around in my garage somewhere.
YES, I am KnotRight sometimes.
YES, I am KnotRight sometimes.
Last edited: