That quick squirt of de-greaser wasn't enough, I like to submerge screws in a small cap.
The sight probably has an oil film in the female threads as well, dip a toothpick, or something similar, and fill the female hole.
Thanks, I'm in!!!hitting up Harbor Freight for one of their sets of 7 for $6.99.
I’d try a higher temp loctite before the hammer technique.Not enough unfortunately. Like he said, the heat from shooting will eventually break down the Loctite. I peened the hell out the sight once in the slot till it doesn’t move. Then I add thread locker. Even then it ends up loosing, just after a much longer period.
I’d try a higher temp loctite before the hammer technique.
Would Locktite Red #271 be appropriate?
you're in what? the female hole???Thanks, I'm in!!!
This. Lot of rounds, burn you hot many times.I've always used blue loctite and never had one loosen on me.
Pretty sure I’m using 243.There are three blue's I'm aware of
That'll do, the 248 paste has never held well for me, and it breaks down at a lower temperature.Pretty sure I’m using 243.