3D printed chamber flag

[Exspiravit]

3D printing is leading to some interesting products in the firearms world. This is sort of minor, but I think it's a really neat idea.

Basically a printed CZ 452/455 mag body with flag attached.

Maybe I'm easily impressed.

 

[dlee12]

I like that, no question on it being empty. Can’t really fall out.

The only downside I see is that its specific to that gun. I tend to just have a handful of generic chamber flags.


Sent from my iPhone using Tapatalk

 

[BASIL]

Debbie downer here.
But that firearm can still have a round in the chamber.

 

[Exspiravit]

Maybe instead of "chamber flag", I should have called it just a safety flag.

I really dislike shoving stuff in my rifle's chamber, even if it is plastic.

 

[9outof10mms]

Am I too much of a jerk to suggest that chamber flags are a bit over the top safety nazi? An open bolt is good enough for me. I don't think I'm being too macho by saying that. If I wanted to be macho, I'd say a general understanding that "if you shoot me, I'mma shoot you" is my level of OK-ness with safety rules. But I'm not gonna say that...out loud.

 

[HMP]

I think what youve printed is pretty cool, but due to price, it's hard not to pick up a pack of 5 or 6 flags for 5 or 6 bucks shipped and fit many calibers.
but I really like what youve done there!

 

[Exspiravit]

I think what youve printed is pretty cool, but due to price, it's hard not to pick up a pack of 5 or 6 flags for 5 or 6 bucks shipped and fit many calibers.
but I really like what youve done there!

Probably also should have clarified that I didn't print it. Seller on Ebay, who just happens to be in NC.

 

[HMP]

Probably also should have clarified that I didn't print it. Seller on Ebay, who just happens to be in NC.

Ah, ok. Thought it was yours.
i was actually going to say that if you did a few different kinds you could likely get some sales

 

[dlee12]

Debbie downer here.
But that firearm can still have a round in the chamber.

Oooh, didn’t even notice that at first glance, good catch.


Sent from my iPad using Tapatalk

 

[Chdamn]

I mean if you’re gonna print one it should be a middle finger sticking up.

 

[Button Pusher]

McFadden Machine makes the grip loader and most of the adapters are printed.

https://www.mcfaden.com/McFadden-Machine-Lightnin-Grip-Loader-s/1828.htm

 

[nbkky71]

Not too bad for a printed item.

I usually use yellow weed eater trimmer line in my rimfire guns to serve as an empty chamber indicator. Just cut a suitable length, tie a knot in one end and maybe add a flag of yellow duct tape. Very inexpensive