Annealeez?

[Tim]

Any of y'all used one of these? I bought it new a couple years ago and it's just sat on a shelf ever since.

Tips? Tricks?

I have some 750* Tempilaq on the way, but does anyone have preferred/suggested run times for 6.5 CM and .308?

 

[jmccracken1214]

I’ve got it. You want the case in the flame 5-6 sec max. 1 Mississippi 2 Mississippi... so on.

 

[grungewehr39]

Again. With the misleading titles.

 

[Tim]

Again. With the misleading titles.

 

[Tim]

I’ve got it. You want the case in the flame 5-6 sec max. 1 Mississippi 2 Mississippi... so on.

Thanks

 

[grungewehr39]

The title. Made me laugh. Made me think.

 

[Bunsen]

Here is a thread that discusses several of the modifications you can do. It goes quite a ways down the rabbit hole on how to maintain a consistent flame via regulating gas pressure.

https://forum.snipershide.com/threads/annealeez-modifications.6501933/

For the money to me the easiest and best bang for the buck is upgrading the torch holder to an articulated arm.

https://www.amazon.com/dp/B01EL9H14S/ref=dp_prsubs_1

I have not spent the $$$ on getting a gas regulator as I tend to do small batches (less than 200 pieces) and my flame does not change too much in that 10-15 minutes it takes to anneal.

Lastly consider upgrading your catch pan to one of these:

https://www.homedepot.com/p/Wal-Board-Tools-12-in-Stainless-Steel-Mud-Pan-23-002/100389948

 

[Downeast]

Here ya go!

 

[backwoodsshooter]

this is what I have thrown around doing.

https://68forums.com/forums/showthr...oject-Complete!-Plans-and-parts-list-included!