How in the hell do you get a Magpul trigger guard roll pin in the lower? I do not want to hammer any harder thinking that I might screw up the lower. And I am using a roll pin punch.
AR trigger guard
- Thread starter KnotRight
- Start date
- Replies 3
- Views 287
You check the roll pin to make sure it’s not flare out? Your putting it to the rear hole right?
Sent from my iPhone using Tapatalk
jmccracken1214
Well-Known Member
you use google, or youtube.
OP
Finally got the pin in. It would go 3/4 and stop. Knocked out a couple of times. Then used a claw hammer and the roll pin punch to get it in. Lower is complete except I forgot the pistol grip. Everytime I go to PSA I buy a few extra parts to build an AR. Glad I did in the past because yesterday they were out of detent pins and detent springs.
Going to be a while to decide on the barrel.
Going to be a while to decide on the barrel.