Wanting to add a 9mm supressor

If the measurements are correct, the skirtless cones at MutedMachineWorks would be ideal blast baffles in stainless. They also sell spacers for the skirtless cones, but its not often everything you want is in stock....just get what you want when you can and get on the email list.

Maverick tubes are thick for the first 2 inches or so (blast chamber).
 
Still been reading a lot on this. What info is needed to go ahead and file the form 1? Just length and cal or do you have to discuss internals and what not? I've only done 1 form 1 and THSF filled it out for me haha.
 
All you need is length and caliber. No discussion of internal or anything like that. The efile website is as bad or worse than any govt website. Looks like it was designed in 1985 but with a little research and practice you can blow through the whole thing in 10 minutes. You can also order fingerprint cards from the ATF for free ( order 50 like I do ) and a $7 fingerprint pad from Amazon and roll your own.
 
Still been reading a lot on this. What info is needed to go ahead and file the form 1? Just length and cal or do you have to discuss internals and what not? I've only done 1 form 1 and THSF filled it out for me haha.
Other than overall length and caliber, you’d need to come up with a serial number and if you wanted to, a model.

The SN has to be Arabic numerals and Roman letters...your basic 0-9 and A-Z. Hyphen is acceptable if you want one. It can be all numerals, or alphanumeric, but it can’t be all letters.

Model has to be engraved if you choose one. I used N/A for all of mine so it was one less thing to come up with and have to engrave.

I have a write-up here that covers most of EForms. The one thing you do need to know that’s different for a Form 1 can is you’ll use FMI as the Manufacturer Code. That’s the proper method when you’re not starting with an actual firearm (so same would go for 80% lower, AK flat, etc). This is different from a paper form where you’d put your name, or entity name, as the original manufacturer.
 
Don't try to come up with a model name unless you want to wait another week or more for model name approval. If its something that isnt in the system you will get a hold put on it where you cannot proceed until its reviewed.
 
Back
Top Bottom