Xl750 priming help needed

Outcrydrummer

Outcrydrummer

Well-Known Member
Joined
Jul 9, 2017
Messages
478
Location
Greensboro NC
Rating - 100%
21   0   0
Hey guys

So just started reloading
Had some light primer strikes and figured out its likely due to my primer seating depth. All of my primers were flush or 0.0005 depth. Was gonna shoot for .005

So ive got the shell plate snugged down as far as i can with shell plate still able to rotate freely.

Still most primers are seating flush or at max .002

Not sure what else to do. Is there any other adjustments or places to look?

Brass looks good
Primer cups look fine
Cci 500 primers

Running out of ideas. Any help appreciated.

Thanks,

Josh
 
Seating depth isnā€™t adjustible. The the extent it can be controlled, you do so by pressing forward with wither more or less pressure.

When you press down on the shellplate at position 4, if it goes down you can tighten the bolt a hair more.
 
Jim is correct. Assuming the primer system is installed correctly, It sounds like you may be short stroking the machine on the upstroke where the priming takes place.


Sent from my iPhone using Tapatalk
 
Last edited:
You must log in or register to reply here.
Back
Top Bottom