Tim
Checked Out
Staff member
2A Bourbon Hound 2024
2A Bourbon Hound OG
Charter Life Member
Benefactor
Vendor
Multi-Factor Enabled
Well…that would make sense.I know zero about AKs, so I’ll just ask. Although it’s a different adapter, I wonder if that one is similar to the one SB makes:
BA-AKNT Brace Adapter | SB Tactical
SB Tactical BA-AKNT Brace Adapter. We design, develop and manufacture accessories for firearms including the original pistol stabilization brace.www.sb-tactical.com
Doesn’t the SBA3 just mount to a standard AR buffer tube? So it might be as simple as removing that brace and replacing it with a stock?
Pretty much this...but I'd just spend the $30 on a fixed stock trunnion and call up @digitalpaladin10 .After you do the paperwork just remove the brace and add the stock. Looks like that is plastic but just like a standard buffer tube.
There are better setup pending what you want.
So that’s not a standard AR buffer tube underneath? I’m not seeing an SBA3 on SBT’s site under AK…so I was assuming it’s their standard SBA3 on an AR tube?To clarify, I built that pistol. It's a BoB build for a friend on here. All BoB builds take normal AK stamped receiver stocks, adapters or braces. Here's a higher res pic. The rear tang bolt goes under the cap on top of the adapter.:
DP
Had not had hands on that gun but guns like it. Yes from what I see.So that’s not a standard AR buffer tube underneath? I’m not seeing an SBA3 on SBT’s site under AK…so I was assuming it’s their standard SBA3 on an AR tube?
While there may be a better option, is the short term/immediate solution to pull the SBA3 and install an AR stock doable?
Thanks!That's right. It is just a standard mil-spec polymer tube underneath that SBA3 brace. That stock adapter is this unit right here:
AK 47/74 TUBE FIXED ADAPTORMIL SPEC - DLG TACTICAL
AK 47/74 TUBE FIXED ADAPTORMIL SPEC - DLG TACTICALPOLYMER TUBES & ADAPTORSwww.dlg-tactical.com
DP
AK 47/74 SHORT CARRY GRIP CAP - DLG TACTICAL
This is the one. You have a milspec trunnion in your receiver.
DP