Channel-3-Project

noway2

Senior Member
2A Bourbon Hound OG
Charter Life Member
Multi-Factor Enabled
Joined
Dec 16, 2016
Messages
21,550
Location
Onboard the mothership
Rating - 100%
5   0   0
Saw it here: https://areaocho.com/channel-3-project/

Since the average citizen is NOT an Amateur Radio operator, there is a need to have a standardized method of being able to communicate with one another. Nearly everyone has at least one form of communication requiring no license to operate: CB, FRS/GMRS, or MURS radios. There is a movement in the prepping community to setup an emergency communications protocol that will allow people to communicate during a situation when communications are down. Because this link-up protocol is being distributed among various circles, if someone needed assistance they have the highest probability of linking up with someone of like-mind, even if the two parties did not personally know each other prior that moment.

Enter the Channel 3 project. The channel three project is where people will monitor the radio on the threes-

  • FRS/GMRS Channel 3 – 462.6125 Mhz
  • MURS Channel 3 – 151.940 Mhz
  • Ham Radio (simplex) – 146.520 Mhz
  • CB channel 3 – 26.985 MHz
Do NOT use sub-channels, TCS, or “privacy” codes

Make Contact In 3 – 2 – 1
– 3 (Turn your radio on and set it to Channel 3)
– 2 (Attempt to broadcast for approximately 2 minutes)
– 1 (Attempt again every 1 HOUR, on the hour, to save batteries)
 
Back
Top Bottom