I have a dead air nomad with a keymo adapter.
Long story short the same flash hider has been p/w 3 times now. It is impossible to remove the can now without a wrench after only tightening it hand tight. It seems every p/w it has gotten worse and worse to break the spring tension on the keymo to now it is unbearable. Brand new flash hider and my nomad goes on/off easily. Easier than my original p/w situation.
Does p/w cause issues on suppressor qd fitment? I have contacted DA but have not gotten a response. At this point I'm thinking i'm SOL
Long story short the same flash hider has been p/w 3 times now. It is impossible to remove the can now without a wrench after only tightening it hand tight. It seems every p/w it has gotten worse and worse to break the spring tension on the keymo to now it is unbearable. Brand new flash hider and my nomad goes on/off easily. Easier than my original p/w situation.
Does p/w cause issues on suppressor qd fitment? I have contacted DA but have not gotten a response. At this point I'm thinking i'm SOL