Picked up a used EMP in 9mm, looks brand new. Ran some factory 9mm though it, did good but felt the slide was dragging towards the rear. I had a case get stuck in it, had to put a brass rod in there and article it with a hammer to get the slide unlocked. After I had it apart I had some brass that would fall in and some didn’t and it all went into my Dillon case gage.
Yesterday I went down to see Jeff Abernathy from Tommy Guns USA. He reamed out the chamber for me he said some run tight. After that the cases just dropped in. He also adjusted the trigger and springs no more drag. Also I noticed absolutely no crown on the end of that bull barrel. So he put one on.
Just writing this in case someone else has one that don’t feel right or cases stick.
Yesterday I went down to see Jeff Abernathy from Tommy Guns USA. He reamed out the chamber for me he said some run tight. After that the cases just dropped in. He also adjusted the trigger and springs no more drag. Also I noticed absolutely no crown on the end of that bull barrel. So he put one on.
Just writing this in case someone else has one that don’t feel right or cases stick.