I was using my autodrum with Titegroup and it did just fine, leaked very very little. But now I’m using much finer H110 to load some .300BLK and I was able to recover 7.4gr of leaked powder after loading only 15rd. That is a 3% loss not counting the powder I wasn’t able to sweep up or capture on printer paper on the floor below.
It seems that the plastic drum is not sealing to the edge of the metal powder drop cylinder(??).
Any tips for fixing leaks?
I already bought replacement drums, no real change.
It seems that the plastic drum is not sealing to the edge of the metal powder drop cylinder(??).
Any tips for fixing leaks?
I already bought replacement drums, no real change.