Hmmm not sure if this qualifies or not.
1st I went in and started putting the stuff away I bought from Catfish.
next I set back and trying to visualize what I wanted to do, with the space that I have.
then, I couldn't help myself, I put on the the hopper I bought to go on top of my tubes for the cases. on my load master. Threw in a few hand fulls and WOW it was full quick! OK so I was wanting to empty my WSF powder to go back to my titegroup. So, what better way than to make more booolits! And since I had got my order in from Midstate, I decided to go ahead and pull the sizer die(from another set of 9mm dies, and replace the primer knock out pin(I ordered 3) I was in oh maybe 30 or so(had already rotated the tubes) (Oh and BTW found one case that was upside down) and all of a sudden POW!!!!!!!!! Pieces flew!!!!! Not sure what happened, or rather why what happened happened, but I broke my priming arm in half! I found the spring, which conveniently found it's way to the top of my bench. So, I got on Lee's site, ordered the parts, which were free, but I have to pay shipping, which shipping is more than the parts! But the worst part, I have to wait on the new parts, before I can operate the machine again. I may have to play with one or two of the other presses, and make some with the single stage, who knows. OR,............ I might take the time sand down my bench and stain it and polyurethane it, since, I will have time now.
Oh the choices! Hope y'all had a better day in "the room"!